国产高跟鞋丝袜在线播放,国产精品亚洲精品日韩已方,国产精品毛片一区二区三区,黑人大荫蒂老太大

Application of "transportation vehicle solid vertical friction - wear repair agent" economic benefit analysis

Project general maintenance application "solid vertical friction and repairing agent" save

Maintenance every 10000 km for the oil one time fee: 360 yuan /22 L, "three": diesel filter two 30 yuan to 90 yuan, oil filter, air filter two is about 50 yuan. A total of 530 yuan, run 100000 kilometers to change 10 times, a total of 5300 yuan. Every 15000 kilometers oil change time, 100000 km to change the oil and the "filter" 7 times, a total of about 3710 yuan of cost. 1590 yuan

Repair engine overhaul costs, running in fuel costs, delay costs about 16000 yuan. Application of "solid vertical friction", every 3 years or 150000 kilometers to add a. 160000000 yuan

Energy saving 100 km fuel consumption of 30 liters, according to 8 yuan / liter, 100000 kilometers fuel costs 240000 yuan. Application of "solid vertical friction", average fuel savings of 4-10% are calculated as 4%, 100000 km fuel costs about 230400 yuan. 9600 yuan

A total of 27190 yuan

Conclusion 1, a Steyr diesel engine driving 100000 kilometers, only save oil and fuel cost of two to 11190 yuan;

2, application of "solid vertical friction" on engine wear "does not collapse," dynamic in situ repair. The friction energy continuously repair wear, when the repair quantity is equal to the amount of wear, repair and wear in a state of balance, will achieve "zero" instantaneous dynamic wear. Thus, greatly prolongs the service life of the engine, reduce mechanical failure, keep the new engine performance, fuel consumption and long-term keep, save energy, save a lot of human, material, and other costs of the loss of working time;

3, avoid at the start of the engine dry friction and wear of engine;

4, improve the power output of the engine, reducing mechanical noise;

5, to reduce the engine emissions of harmful gases up to 60%.

Results 1, prolonging the service life of the engine, the engine working process of the wear parts repair to, or close to the original size of the friction pair, formed on the surface of metal ceramic layer, automatic optimization with the gap, so that the performance of the engine running at or near the new machine water

Flat, and prolonging the service life of 2-4 times.

2, repair of piston ring cylinder, crankshaft bearing, gas distribution mechanism, friction and wear;

3, the fuel consumption is obviously reduced (idling fuel consumption saving up to 30%);

4, improve the oil pressure to the rated value;

5, and improve balance cylinder compression pressure;

6, increase engine power, improve the acceleration performance;

7, the reduction of vibration and noise of engine;

8, to extend the maintenance cycle 1-3 times;

9, eliminate the bad effect of the engine cold start;

10, if appear lubricating oil leakage, safe driving can withstand low, medium speed 200km;

11, energy saving and environmental protection, reducing harmful gas emissions.

(to a Steyr diesel engine driving 100000 kilometers as the calculating unit)